Honda Outboard Motor outboard motor User Manual download pdf (Page 102)

−

100

WATER SEPARATOR

BUZZER SOUNDS

TAKING CARE OF UNEXPECTED PROBLEMS

WATER SEPARATOR

COOLING SYSTEM INDICATOR

When the water separator buzzer

sounds (a rapid, repeating signal):

If there is no water flowing from the

cooling system indicator, stop the

engine and check the discharge port

first then tilt the outboard motor to

inspect the water intake screens. If

clogged, clean the water intake

screens, return the outboard motor to

the running position, restart the

engine, and check the cooling system

indicator again.

If there is still no water flowing from

the cooling system indicator, or if the

engine protection system remains

activated after 30 seconds, return to

the nearest boat landing, and have the

outboard motor inspected by an

authorized Honda Marine dealer.

If the engine is stopped after running

at full throttle, and then restarted

soon afterward, that could activate

the engine protection system

momentarily.

If overheating activates the engine

protection system, idle the engine in

neutral, and check the cooling system

indicator.

If water is flowing from the cooling

system indicator, continue idling for

30 seconds. If the cooling system is

OK, the overheat indicator should go

off within 30 seconds, and the engine

will respond normally to throttle

control lever operation.

Check the water separator for water

contamination. If water is present,

stop the engine, and clean the water

separator following the instructions

on pages , or consult with

an authorized Honda Marine dealer.

77 78

11/03/17 10:49:47 31ZY2630_101

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 134 135

Comments to this Manuals

No comments