Honda HRC216PDA User Manual download pdf (Page 3)

SAFETY LABEL LOCATIONS

These labels warn you of potential hazards that can cause serious

injury. Read them carefully. If a label comes off or becomes hard to

read, contact an authorized Honda servicing dealer for a replacement.

SETTING UP YOUR

NEW MOWER

Loose Parts

Use the following included loose parts to set up the lawn mower.

Handlebar Setup

1. Pry open the right side handle support hanger, and place it over

the right handle above the starter rope guide. Squeeze the ends

together. Make sure the ribs are facing out, as shown.

2. Slip the left handle support hanger over the end of the handlebar

and slide past both bolt holes. Make sure the ribs are facing out.

3. Position the handlebar onto the handle stay, and loosely install the

two 8 x 16 mm flange bolts through the handlebar lower bolt holes.

DO NOT OPERATE UNLESS GUARD

IS CLOSED OR BAG IS IN PLACE

HOT MUFFLER CAN BURN YOU.

Stay away if engine has been running.

KEEP HANDS and FEET AWAY

Part Quantity

Handle support plate

Handle support hanger

Flange bolt (8 x 16 mm)

Flange bolt (8 x 40 mm)

Self-locking nut (8 mm)

RIBS

OUT

STARTER ROPE

GUIDE

RIBS OUT

8 x 16 mm

FLANGE BOLT (2)

HANDLE STAY

1 2 3 4 5 6 7 8 ... 23 24

No comments

Honda HRC216PDA User Manual Page 3