Honda FG400 User Manual download pdf (Page 24)

~~~~~~

Tiling Depth Adjustment

The drag bar is used to control the tilling depth, which can be adjusted by

removing the pin and retainer and sliding the drag bar up and down as

necessary.

During operation,

the machine jerks forward while tilling, press down on the

handlebars. This will cause the drag bar to dig more deeply into the soil.

Front Wheel

After getting to the tilling site, move the front wheel to the raised position before

tiling. Always stop the engine before lowering or raising the wheel.

To raise or lower the wheel, pull out the wheel assembly, move the wheel, then

release the wheel assembly.

TILLING POSITION

TRANSPORT POSITION

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 63 64

No comments

Honda FG400 User Manual Page 24