Honda 2011 Pilot User Manual download pdf (Page 42)

42 Navigation System

Entering a Destination

Showing the Map of State

With the State selection, the display

changes to the Select a state screen.

After you select the desired state, the

display changes to a map of the state,

with the crosshairs located near the

middle.

The yellow box indicates the area you

will see when you click on the current

map with the Interface Dial. The scale

will decrease each time you push in on

the Interface Dial, until Select a

destination appears at the top of the

screen.

Use the Interface Dial to move the

crosshairs to the area of the state close

to your intended destination. If desired,

rotate the Interface Dial knob to

change the map scale. When you have

the crosshairs in the desired area, push

in on the Interface Dial. The address

of the location you have selected will

appear at the top of the screen.

NOTE:

The selected icon or road segment is

displayed on the 1/2 mile (800 meter) or

less map scale.

If this is the desired address, push in on

the Interface Dial again. If not, use the

Interface Dial to reposition the

crosshairs, then push in on the

Interface Dial again to display the new

address.

If you selected a single icon or road

segment, select Set as Dest. to

calculate a route to the selected

destination. If you selected multiple

icons within the cursor radius, select an

item from the list. Then select OK to

calculate a route to the selected

destination.

2011 Pilot

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 158 159

Comments to this Manuals

No comments