Honda FG110 User Manual download pdf (Page 14)

TRANSMISSION LUBRICATION

The transmission is pre-lubricated at the factory.

At the beginning of each tilling season, or after every 25 hours of use

during the season, the transmission should be filled with grease.

Replacement grease should be a high quality petroleum based

NLGI #2 general purpose grease usually available in disposable tubes

at most hardware or automotive parts stores.

1. Place the tiller on the left side as shown.

2. Remove the lock pin from the right side tine shaft by turning it UP

[a] and pulling it out [b] as shown. Wearing heavy gloves, remove

both right side tines.

3. Remove the air vent screw and fill hole screw from the

transmission.

4. Fill the transmission by using a grease gun or grease applicator at

the fill hole screw opening. Push the gun or applicator against the

opening so as to seal the nozzle of the gun or applicator against

the casting embossment. Apply grease until grease begins to

come out of the top air vent hole.

5. Reinstall the air vent screw and fill hole screw.

6. Clean the tine shaft and place a few drops of oil on the tine shaft

before installing the tines.

7. Wear heavy gloves and reinstall the tines in the reverse order of

removal.

8. Install the lock pin [c] through the round side of the tine shaft hole

then turn it over [d] to lock it in place.

[d]

[c]

RIGHT OUTER

TINE

GREASE

GUN

AIR VENT SCREW

OPENING

RIGHT INNER

TINE

FILL HOLE SCREW

OPENING

[b]

[a]

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

No comments

Honda FG110 User Manual Page 14