Honda FS7054 User Manual download pdf (Page 22)

MAINTENANCE & ADJUSTMENTS

BROOM

REPLACEMENT

Whenever the broom becomes excessively tapered,

worn past the service limit or sweeping is difficult,

replacement is necessary.

""i

SERVICE

1/2 inch

Broom

Removal

1. Make sure the engine is turned off, the ignition key is removed, and the spark plug cap(s) are

Use the sweeper lift crank to raise the broom until it is just slightly off the ground.

3. Remove the drive chain retaining clip, and remove the master link from the drive chain. The retaining

disconnected.

clip can get bent or damaged during removal,

never reuse the clip. Always install a new master link

during assembly.

Unbolt the two pillow block bearings from the sweeper hood by removing the four 3/8

16 inch carriage

bolts.

Use the sweeper lift crank to raise the sweeper hood above the broom assembly.

Roll

the broom

assembly out from under the sweeper hood.

3/8-16" CARRIAGE

BOLT

(4)

3/8" NUT (4)

FS7054

SWEEPER

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

No comments

Honda FS7054 User Manual Page 22