Honda HRC7018 User Manual download pdf (Page 57)

MAINTENANCE & ADJUSTMENTS

Hydrostatic Oil

Hydrostatic Oil Capacity: 10.4 quarts, 9.8 liters

Checking the Level

Remove the cap on the

reservoir.

2. The oil level should be even

with the lower hole. Add oil to

bring it to the correct level.

Oil Recommendation

SAE 1 OW-40 engine oil

meeting or exceeding API

Service Classification SG.

Changing the Oil

Change the oil at the recommended interval or more

frequently under extreme operating conditions.

Drain the oil while it is warm to assure rapid and complete

draining.

1. Install one end of a section of l/z inch hose over the drain

outlet and place the other end in a suitable container to catch

the used oil.

2. Clean the area around the oil filler cap and remove it.

3. Turn the drain valve counterclockwise about 4 turns to open

it. Do not open the valve more than 6 turns to avoid

damaging the seals.

4. When the oil has drained, turn the valve clockwise to close it

and remove the section of hose. To avoid damaging the

valve, do not over tighten it.

5. Refill the reservoir with the correct amount of the

recommended oil.

6. Start the engine and allow it to idle for 3 to 5 minutes to

circulate the oil and allow any trapped air to escape.

7. Stop the engine and recheck the oil level.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 99 100

No comments

Honda HRC7018 User Manual Page 57