Honda SB7038 User Manual download pdf (Page 14)

SB7038 Snowblower

Assembly and Installation

Deflector Cable Assembly

Remove the forward throttle mounting screw, and use it

to temporarily hold the cable bracket in position.

The cable bracket will be used as a guide to mark, and

drill the two mounting bolt holes in the handle tube.

Position the cable bracket so it is parallel to the right side

handle tube.

Use a center punch to mark the center of one of the

holes in the upper bracket. Put on safety glasses and drill

a 21/64” hole into the handle tube. Install a bolt through

the drilled hole to hold the location, and drill the second

hole through the handle.

Remove the cable bracket and deburr the drilled holes in

the handle tube.

Put the cable bracket and spacer into position and secure

them with the throttle screw and two 5/16x2” bolts,

washers, and flange nuts as shown.

Carefully stretch the protective plastic boot over the

choke knob. Use the small 4” cable tie to secure the boot

to the underside of the choke knob.

This plastic boot will help prevent snow and moisture

from getting into the choke cable.

CABLE BRACKET

5716 x 2” HEX BOLT (2)

5/16” FLAT WASHER (

5/16” FLANGE NUT (2)

PLASTIC BOOT

4” CABLE TIE

FASTEN BOOT

UNDER CHOKE

KNOB

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

No comments

Honda SB7038 User Manual Page 14