Honda SB7038 User Manual download pdf (Page 9)

Assembly and Installation

SB7038 Snowblower

Remove the Mower Deck

1. Follow the procedure in the HRC 7000~series Owner’s Manual or Shop Manual and remove the

mower deck from the power head.

2. Save the bolts and flange nuts to use with the mower deck when it is reinstalled.

Install the Tension Release Control (hydrostatic drive models)

1. Assemble the pivot pin on the release plate with three 5/l 6” flat washers and a cotter pin as shown.

2. Raise and support the rear of the power unit to reach the pump belt tensioner.

3. Remove the tensioner pivot bolt and belleville washer.

u ./ RIGHT PUMP PULLEY

FLANGE NUT

LEFT PUM+ PULLEY

CRANKSHAFT

PULLEY

TENSIONER

TENSIONER PIVOT BOLT’

S/32” SPACER

Install the belleville washer, release plate, and

spacer over the new pivot bolt.

Install the pivot bolt through the tensioner and

into the engine bed. Install the flange nut on the

tensioner bolt and tighten the bolt.

BELLEVILLE

PLATE

5116” FLAT -

WASHER (3)

PIVOT PIN

’

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

No comments

Honda SB7038 User Manual Page 9