Honda SB7038 User Manual download pdf (Page 25)

Maintenance & Adjustments

SB7038 Snowblower

Gearbox Oil

The oil level in both the front and rear gearbox must

be checked every 25 hours.

Park the snowblower on a flat, level surface.

Remove the belt cover. Locate the oval cutout in

either side of the the rear gearbox mounting

bracket. Remove the oval plug; the oil level should

reach the plug hole opening.

INSPECTION PLUG

For the front gearbox, locate the inspection plug on

the front of the gearbox. The oil level should reach

the plug hole. Remove the vent plug on the top of

the gearbox should oil needed to be added.

Fill both gearboxes with AGMA 5 EP or SAE 90

hypoid gear oil as needed.

Other Maintenance Items

Shear Bolt Replacement

The auger and discharge fan both have special shear bolts that are

designed to break if either the auger

or fan are put under an excessive load. In the event a shear bolt does break, replace it with an original

Honda shear bolt. See the parts listing for the locations of the two shear bolts.

Extra shear bolt hardware is included with the snowblower and may also be purchased from an servicing

Honda commercial mower dealer..

Belt Replacement

Adjust the belt according to the instructions in the mid-size

commercial mower owners manual or shop manual.

To remove the belt from the gearbox pulley, loosen the top

nut on the belt guides, and lift the belt off of the pulley.

OSEN TOP NUT ONLY

POP 52173 (9511)

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

No comments

Honda SB7038 User Manual Page 25