Honda 2-DOOR DX User Manual download pdf (Page 11)

PRELIMINARY

47. Remove the cap from the expansion valve. Get

the stud bolt from the kit, and secure its short M6

side to the expansion valve.

48. Get pipe stay A and B from the kit. Secure pipe

stay A to the rear of the engine mount vibration

bracket with one 6 mm x 16 mm washer-bolt and

torque to 7.2 lb·ft. Secure stay B to the front of

the engine mount vibration bracket with one 6 mm

x 16 mm washer-bolt and torque to 7.2 lb·ft.

Attach the plastic clip to stay B.

49. Get the aircon pipe from the kit. Remove the cap

from the flange end of the aircon pipe and lightly

oil the O-rings with PAG oil. Guide the flange end

of the aircon pipe over the stud bolt of the

expansion valve and push the O-ring fittings into

the expansion valve. Secure the flange with the

M6 nut from the kit.

51. Get pipe stay A and B and the clip from the kit.

Secure pipe stay A to the rear of the engine mount

vibration bracket with one 6 mm x 16 mm washer

bolt. Attach the clip to stay B and secure stay B

to the front of the engine mount vibration bracket

with one 6 mm x 16 mm washer bolt and torque to

7.2 lb·ft. Attach the plastic clip on the aircon pipe

to stay A through the rectangular hole.

52. Get the clamp from the kit, attach it to the suction

hose and then to pipe, stay B with one 6 mm x 16

mm washer bolt and torque to 7.2 lb·ft. Attach the

receiver pipe to the clip on stay B.

50. Remove the caps from the suction hose and

receiver pipe coupling and lightly oil the O-rings

with PAG oil. Remove the caps from the mating

coupling of the aircon pipe, and connect the

couplings hand tight. Secure the couplings, for the

receiver pipe with a 17 mm & 19 mm combination

wrench and for the suction coupling with a 24 mm

and 27 mm combination wrench. Do not over

tighten.

1 2 ... 6 7 8 9 10 11 12

No comments

Honda 2-DOOR DX User Manual Page 11